NEW PRODUCTS
Alinco DJ-496T UHF FM Hand held Transceiver
Alinco has created a new UHF FM Hand held Transceiver that sets new standards in features, convenience and easy operation. The DJ-496T sports an alphanumeric display for easy memory management. It has an ergonomic design that's "user friendly" and the 4 watt output battery is standard. You'll be ready to travel the world with CTCSS encode+decode, DCS and European tone bursts, all included at no extra cost. Best of all, the DJ-496T retains the proud Alinco tradition of quality construction and excellent value.
- Alphanumeric display
- 40 memory channels + Call Channel
- Backlit Keypad
- 4 watt output with standard battery
- CTCSS encode+decode and DCS
- 13.8 VDC direct input with battery charge feature
- Direct frequency input
- S-meter
- Autodialer
- Cable Cloning
- Computer programmable (third party software required)
- MARS/CAP capability
- Additional features, including theft alarm!
| Alphanumeric Display | Label channels in an easy-reading format. Display frequency, alpha label or channel number only. |
| 40 Memory Channels + Call Channel | Plenty of room to store your favorite simplex or repeater frequencies along with alphanumeric label, offset, CTCSS encode/decode or DCS setting. |
| 4 watts output |
The standard battery allows the DJ-496T to produce up to 4 watts. A power input port Accepts 13.8 VDC and charges the battery, but won\\\'t allow destructive overcharge. |
| CTCSS, DCS, Tone Bursts and DTMF | Be prepared for virtually any selective calling situation or gaining access to repeaters with protected inputs. European Tone Bursts include 1000, 1450, 1750 and 2100 Hz. |
| Direct Frequency Input | Frequency entry is easy using the well-spaced keypad. |
| S-Meter | Displays relative signal strength. |
| Cable Cloning | Share identical settings among multiple DJ-496T transceivers. Saves time and ensures uniform operation. |
| Theft Alarm | The DJ-496T can be set to emit a tone when disconnected from an external power source until proper action is taken to silence the alarm. |
| Experimental Insect Repel Feature | Can the DJ-496T actually repel mosquitoes? Activate the special tone and decide for yourself! You may find the DJ-496T can \\\"de-bug\\\" your outdoor operating site! |
| General | DJ-496T |
| Freq. RX original status | 430 to 449.995 MHz |
| Freq. Stability | +/-5 ppm |
| Antenna Imp. | 50 ohm unbalanced |
| Supply Voltage | DC 13.8V rated |
| | DC 7.0min to 16V max |
| Ground | Negative GND |
| Current consumption | TX 5W 1.4A approx. |
| at 13.8V external source | RX 200mA approx/280mW |
| | RX squelched 50mA approx. |
| | RX Batt.Save on 20mA approx. |
| Operating Temp. range | -10 to +60 degrees C. |
| Dimention w/o projection | 56(W) x 124(H) x 40 (D) |
| Weight with EBP-48N | Approx. 375g (13.2oz) |
| Transmitter | |
| Output power | 5W 13.8V or 4W EBP-48N |
| | Low=0.8W |
| Modulation | Variable reactance FM |
| Max. Deviation | +/- 5kHz |
| Spurious emission | less than -60db |
| Microphone Imp. | 2k ohms approx. |
| | |
| Receiver | |
| Circuit | Double superheterodyne |
| 1st IF freq. | 45.1Mhz |
| 2nd IF freq. | 455khz |
| | |
| Sensitivity 12db SINAD | better than -12dBu |
| | (0.25uV or less) |
| | |
| | |
| Selectivity | more than -6dB/12kHz |
| | less than -60dB/26kHz |
| Audio output power | 280mW |
| Audio impedance | 8 ohms |
File belum tersedia
